Bass drop D tuner

Tune your bass to bass drop D (D A D G) with your phone or computer microphone. Press start, play a string and follow the needle.

Quick answer

Bass drop D, low to high: D A D G. From bass standard tuning: 4th E to D (-2).

Mic off
D1
Tap start, then play any string

Too low (flat)? Tighten the peg. Too high (sharp)? Loosen it.

  1. Click Start tuner and choose Allow when the browser asks for the microphone.
  2. Hold the bass close to your laptop. The mic is usually next to the camera above the screen.
  3. Play one string and let it ring. Follow the needle to the middle.

Allow the microphone, then play one string close to your phone.

Sound stays on your device. Nothing is recorded or uploaded.

Instrument

Bass with the low E dropped to D

Strings, low to high

Tap a string to hear its note. While the tuner listens, tap one to lock onto it.

Reference pitch A4 = 440 Hz

Leave this at 440 unless you are matching a piano or a record that is off standard pitch.

For screen readers: announces the note and which way to turn the peg about every 1.5 seconds while a string rings. Press R for a reading any time.

Each string and its pitch. Tap to hear it.

Bass drop D notes and frequencies

Bass drop D: notes and frequencies with A4 = 440 Hz
StringNoteFrequency
4D136.71 Hz
3A155.00 Hz
2D273.42 Hz
1G298.00 Hz

Bass drop D is D A D G, from the lowest string to the highest. The 4th string drops a whole step from E to D, giving a low D of about 36.7 Hz for heavier riffs and songs in D. The other three strings stay at standard.

The lowest note is D1 at 36.71 Hz. Phone and laptop mics pick up notes this low weakly, so pluck firmly close to the mic. Or start the tuner, tap the 4th string to lock onto it, and play its 12th-fret harmonic: it sounds an octave higher (73.42 Hz) and the locked tuner reads it as that string.

Change from bass standard tuning

Bass drop D compared with bass standard tuning, string by string
StringBass standardBass drop DChange in semitonesNew frequency
4E1D1-2 (down a whole step)36.71 Hz
3A1A1Same55.00 Hz
2D2D2Same73.42 Hz
1G2G2Same98.00 Hz

1 of 4 strings change; the other 3 stay where they are.

How to get from bass standard tuning to bass drop D

  1. Lower the 4th string a whole step from E to D until it sounds one octave below the open 2nd string (D).

Or skip the ear work: pick Bass drop D (DADG) in the tuner above and follow the needle on each string.

Using the bass tuner

  1. Press Start tuner and allow the microphone.
  2. Play one string of your bass at a time and let it ring.
  3. Tune up if the needle sits left of center and down if it sits right. The note turns green within 3 cents.

Related tuners

Bass strings and gear

Bass strings last a long time, so a good set is worth it. Buy 5-string sets if you have a low B.

  • Our pickD'Addario EXL170

    The most common 4-string bass set. Bright and even.

    View on Amazon
  • Ernie Ball Regular Slinky Bass

    A punchy round-wound set loved by rock players.

    View on Amazon
  • D'Addario EXL170-5

    The 5-string version, with a low B that stays clear.

    View on Amazon
  • Korg Pitchclip 2

    A small clip-on chromatic tuner that works on bass and guitar.

    View on Amazon

See all guitar stringsGear for you

As an Amazon Associate GuitarMath earns from qualifying purchases. How we choose gear.

Common questions

What notes are in bass drop D tuning?
D1 (36.71 Hz), A1 (55.00 Hz), D2 (73.42 Hz), G2 (98.00 Hz), from the lowest string to the highest.
How do I tune to bass drop D from bass standard tuning?
Lower the 4th string a whole step from E to D until it sounds one octave below the open 2nd string (D).

Last updated November 15, 2026.